The
AZZA
U694 MAINBOARD SERIES
Page 13
2.4.1. Installation of the CPU
To install your processor, please complete the following set of instructions
1. Locate a small dot marked on the top of the CPU. This mark indicates Pin 1 of
the CPU.
2. Locate Pin 1 for the Socket on the mainboard.
3.
There is a lever on the side of the socket. First push this lever sideways and
then lift it to a 90-degree angle.
4.
Insert the CPU into the Socket. Please make sure that Pin 1 for the CPU is in-
serted into Pin 1 of the Socket.
5. When the CPU is installed correctly push the lever back into place.
6.
Install a proper heat sink with cooling fan
for proper heat dissipation.
Failing to install a heat sink with cooling fan may cause overheating which will
burnout your CPU and damage your mainboard.
2.4.2. Memory Modules
These mainboards all have three 168-pin DIMM slots and are able to support a maximum
memory of 1.5 GB. The DIMM slots are located on the right hand side of the board. To
install the DIMM’s into these slots, make sure the white lever at each side of the slot has
been pulled down to an angle of approximately 45°. Make sure that the DIMM is in the
correct orientation. Place the DIMM on the slot and push down firmly.The white levers will
come back up and lock the module in place.
Important: The DIMM’s can only be fitted into the slots in one orientation.
Make sure that the DIMM’s are in the correct orientation and the pins are cor-
rectly aligned before you insert them.
Hardware Installation
2.4. CPU, Memory and Expansion Slots
Top View of a 168-pin DIMM Slot
IMPORTANT: CPU COOLING FAN
Please ensure that you have an approved heat sink with cooling fan. Without a
proper heat sink with cooling fan you will damage both the mainboard and the
CPU.
