PT-6IFB
SYSTEM BOARD
AWARD BIOS SETUP
I.
10
PCI-AUTO : The BIOS will scan for PCI IDE devices and determine the location of
the
PCI IDE device, then assign IRQ 14 for primary IDE INT#, and assign
IRQ 15 for secondary IDE INT#.
PCI-SLOT1 : For the specified slot, the BIOS will assign IRQ 14 for primary IDE
INT#,
to and assign IRQ 15 for secondary IDE INT#.
PCI-SLOT4
ISA
: The BIOS will not assign any IRQs even if PCI IDE card is found.
Because some IDE cards connect the IRQ 14 and 15 directly from ISA
slot thru a card. (This card is called Legacy Header)
Used MEM base addr and
Used MEM Length
:
These fields are used for some specific ISA legacy cards with requested memory space
below 1M address. You can define where the used memory address is located and its
length of the legacy area corresponding. Base on these, BIOS will skip the UMB area
that is used by the legacy device to avoid the memory conflict.
Note : No matter the item "Resources Controlled By" is set to "Manual" or "Auto",
the
system BIOS assign IRQs to PCI devices from high to low. For ISA PnP
devices, the sequence is from low to high.
A.
INTEGRATED PERIPHERALS
ROM PCI / ISA BIOS (2A69HXXX)
INTEGRATED PERIPHERALS
AWARD SOFTWARE, INC.
IDE HDD Block Mode
:
Enabled
Onboard Parallel Port
: 378/IRQ7
IDE Primary Master PIO
: Auto
Parallel Port Mode
: SPP
IDE Primary Slave PIO
: Auto
IDE Secondary Master PIO
: Auto
PHONERING WAKE UP
: Disabled
IDE Secondary Slave PIO
: Auto
On-Chip Primary PCI IDE : Enabled
USB Controller
: Disabled
On-Chip Secondary PCI IDE : Enabled
PCI Slot IDE 2nd Channel
: Enabled
KBC input clock
: 8 MHz
Onboard FDD Controller
: Enabled
