- 12 -
Throughput Test
Bluetool contains a throughput test feature that can be used with two or more AW-NM230NF-H devices. Note that
each device runs on a separate PC with BlueTool installed. This document will provide basic directions for setting-up
and running this test.
The next step in setting-up the test is establishing a connection between the devices.
ESTABLISH A BLUETOOTH CONNECTION BETWEEN TWO USB DEVICES
SET UP THE SLAVE DEVICE FIRST
1.
On the
Slave
side, start Bluetool from the Start Menu.
2.
If the Log Window is not already open, select “View” and then select “Log Window”.
Select “Transport” and
then Select “HCI Control.” New window pop-up, select “UART” and enter com port number. Click
“OK”.
3.
Download mini driver (see 3.1)
4.
In the “HCI Control” window, select “7.3 Host Controller & Baseband Commands” (Note: may be 4.3,
depending on version)
5.
Double Click the “Write Scan Enable” entry
6.
Select “Inquiry and Page Scan Enabled” and click “OK”
7.
Double Click “Set Event Filter”
8.
Select “Connection Setup”
9.
Select “Allow Connections from all devices”
10.
Select “Do Auto accept the connection with role switch disabled”
11.
Click “OK”
12.
In the “HCI Control” window, select “0 Vendor-specific commands”.
13.
Double Click the “Write_BD_ADDR” command
14.
Enter 001122334455
15.
In the “HCI Control” window,select”0 Vendor-specific commands”. Double Click ”Update UART Baud Rate”.
Select 3000000 then click OK.
SET UP THE MASTER DEVICE, AND CREATE THE CONNECTION
1.
On the
Master
side, start Bluetool.
2.
Open the log window, if not already open, and open the UART HCI Transport.
3.
Download mini driver (see 3.1)
4.
In the “HCI Control” window, select “7.1 Link Control Commands” (Note: may be 4.5 depending on version)
