Aztech DieMaster DM-40 series, User Manual

Page: 7 / 56

AZTECH CONVERTING SYSTEMS
DM-40XX
USER MANUAL
5
90PSI
INCOMING
HP AIR
PNEUMATIC CONNECTIONS:
Although
your machine has been thoroughly tested
before shipment, connections on occasion
may loosen during shipment. Visually inspect
all pneumatic to assure that each is fitted
securely. Connect airline to the pneumatic
control panel at the back of the machine (see
figure 2-B), and listen for any air leaks that
may exist. Check all switches by switching
back and forth from on and off to make sure
they are operating properly.
NOTE: Red lines on air dials indicate proper default settings.
2-5: Testing Before Operation
Make sure the area around your machine is clear of any objects which may impair the machine.
Also inspect and make sure all belts, pulleys, rollers, and spindles are free and clear of any
objects which may impede operation, and risk machine damage. Before threading your machine,
accelerate and decelerate your machine through a full range of speeds, and make sure acceler-
ation is smooth and free of any unnatural sounds or movements. Using control switches, switch
Unwind and Rewind Spindle(s) from on and off positions making sure the pneumatic system is
performing properly. Then turn power on, run machine at low speed to assure machine is working
properly. Then with speed set at maximum setting, press the stop button to assure that the brake is
working properly.