—– 4 —–
SET-UP AND OPERATION
Recommended initial Set-up procedure and selectable features:
1.
Select
SAB
or
SCB
mode as required using the appropriate jumper.
2.
Check that the
‘
Timer’
jumper is set to
5 second Test.
3.
Place the
Battery
jumper in the
ON
position.
4.
The sounder will now operate for 5 seconds, and then stop. The twin LED’s will start to flash
simultaneously at five second intervals and continue thereafter.
( Please note that a low volume or irregular sounder noise during this test may merely indicate that your on-
board NiMH battery needs charging. Once connected to your Control Panel the battery will automatically begin
to charge and the sounder attain full decibel output).
5.
Move the
Timer
jumper to the 9 or 15 minutes sounder cut-off position as required. The
sounder will remain silent.
6.
Place the Bell box front cover over the backplate and locate into position. You should hear
the click of the microswitch depressing as the cover locates. Secure with the fixing screw
provided and insert the protective screw cap.
7.
The Sound Unit is now in ‘muted’ alarm condition and should remain
silent until connection
to the Control Panel is completed. The twin LED’s will continue to flash simultaneously
indicating that muted alarm status mode is applied.
8.
Complete all connections to your Control Panel utilising the panels own installation guide or
our wiring guide at the rear of this manual.
9.
Once power is applied to the Control Panel the External Sounder’s Twin LED’s should
commence flashing alternately indicating that set-up and wiring are complete.The unit is now
in stand-by mode and a ‘hold-off’ voltage is present.
10.
From the Control Panel perform Sounder and Strobe tests. Most Control Panels have test
operation modes detailed within their instruction manuals.
Your AZ-TECH Sound Unit is now installed and ready to operate!
