IQ Switch
®
ProxFusion
®
Series
3
Setting up the IQS323 Touch Buttons Module
This module uses mutual capacitance mode and the EV-Kit can be set up as follows:
>
Plug the module into the CT210A via ribbon cable
>
Run the IQS323 GUI
>
Click "START STREAMING"
>
Click "USER SETTINGS"
>
Select the "EVKit Modules" tab
>
Select the image below "Three Button" and minimise the pop-up window
>
Click "ACK RESET"
The GUI should now look like the following:
Channel 0 represents Button number 1. Channel 1 represents Button number 2. Channel 2 represents
Button number 3. The LED will turn on when any channel has detected a "Touch" event.
When evaluation is completed, click "STOP STREAMING".
Copyright © Azoteq 2022
All Rights Reserved
IQS323EV02 User Guide
Revision v1.0
Page 5 of 9
October 2022
