IQ Switch
®
ProxFusion
®
Series
2
Setting up the IQS323 Touch Slider Module
This module uses self capacitance mode and the EV-Kit can be set up as follows:
>
Plug the module into the CT210A via ribbon cable
>
Run the IQS323 GUI
>
Click "START STREAMING"
>
Click "USER SETTINGS"
>
Select the "EVKit Modules" tab
>
Select the image below "Slider" and minimise the pop-up window
>
Click "ACK RESET"
The GUI should now look like the following:
Channel 0 represents the left of the slider. Channel 1 represents the middle of the slider. Channel 2
represents the right of the slider. The LED will turn on when a touch is made on the slider. The slider
bar at the bottom of the GUI shows the relative position of the finger on the slider.
When evaluation is completed, click "STOP STREAMING".
Copyright © Azoteq 2022
All Rights Reserved
IQS323EV02 User Guide
Revision v1.0
Page 4 of 9
October 2022
