IQ Switch
®
ProxFusion
®
Series
1
Introduction
This user guide describes the operation of the IQS323EV02 Evaluation Kit. The EV-Kit consists of:
>
1 x Touch Slider Module
>
1 x Touch Buttons Module
>
1 x L-Sense (Inductive Sensing) Module
>
10 x IQS323 IC’s
>
1 x CT210A
>
1 x Ribbon Cable
>
1 x Piece of Perspex with Conductive Tape
>
1 x Complimentary USB Flash Drive
(Please Note: USB flash drive not included in all kits)
To visualise the sensor data from the EV-Kit, the module can be interfaced with any Windows PC
that supports USB. This is done with the CT210A and the relevant IQS323 software Graphical User
Interface (GUI) available for download from Azoteq’s website. The purpose of the IQS323EV02 EV-Kit
is to help application development engineers in evaluating the IC’s capabilities. The content of the
evaluation kit is shown below.
Download the GUI from Azoteq’s website:
https://www.azoteq.com/product/iqs323/
The GUI can be found in the following section:
>
Design Support
→
Software
>
Click the
Debug and Display tool for IQS323
hyperlink to download the GUI.
>
Install the downloaded GUI.
>
Connect the CT210A to the PC with a micro USB data cable.
Copyright © Azoteq 2022
All Rights Reserved
IQS323EV02 User Guide
Revision v1.0
Page 3 of 9
October 2022
