AZIMUT FP 36, Instructions For Installation And Use Manual

Page: 9 / 46

8
Instruction for use
Attention! Before the first use of the device you must remove protection foil from all surfaces and wash the
device with moist cleaning cloth dipped in the water with detergent. Than dry it with cloth.
Always open and close the pizza oven doors by use the handle. Always wear heat resistance gloves
to protect yourself. Never cover pizza oven with anything during operation, even partially.
FP 36 a FP 36 R, FP 66 R
In order to switch on the oven, turn clockwise the knob of the timer until reaching the requested time of
cooking from 0 to 15 minutes. The orange light turns on to signal that the appliance is on. In order to use
the oven without timing, you can choose the manual mode by turning the knob unclockwise until pointer
is in the position ON. To regulate the temperature of the oven, turn clockwise the thermostat knob until
reaching the requested temperature between 50 and 300 degrees. When temperature is reached, the
green light turn off. To turn off heating elements before set time, turn slowly timer knob unclockwise until
reaching the 0 position.
Take care, as forced operation can damage it seriously!
FP – 37,67 R a FP – 38, 68 R (RS)
Start the oven by turning the main switch to point “I“, according to the label on the knob. The machine is
now switched on. Use the regulation buttons on the thermostat to independently regulate the upper and
lower heating elements, which are switched on after the required temperature is set. The pilot lights for
the upper and lower part of the chamber light up when the heating elements are on. To turn the heating
elements off set the thermostat for the specific level to 0°C. The interior chamber lighting is turned on by
pressing the backlit switch, switching it to “I“, and turned off by switching it to “O“. The lighting only works
if the oven is turned on using the main switch.
Switching off
To turn the oven off make sure that the interior lighting and the heating elements have been turned off,
then turn the main switch to “0“.
Chamber cleaning