AB-6584
2
Safety Instructions
Please read instructions carefully and use the product as specified in this manual. Be sure to keep this manual near by for ready
reference.
Usage Restrictions
This product is targeted for general air conditioning. Do not use this product in a situation where human life may be affected. If
this product is used in a clean room or a place where reliability or control accuracy is particularly required, please contact Azbil
Corporation’s sales representative. Azbil Corporation will not bear any responsibility for the results produced by the operators.
WARNING
•
DANGER: To prevent the risk of severe or fatal electrical shock, always disconnect power source and product
power supply before performing any wiring.
•
Be sure to ground with 100
Ω
or lower ground resistance. Improper grounding may cause electrical shock or
equipment damages.
•
Do not detach the terminal cover at any time except when wiring. After wiring, be sure to attach the terminal cover.
Before attaching/detaching the terminal cover, make sure that the wires are not current-carrying to prevent
electrical shock.
•
Disconnect power before the product replacement to prevent electrical shock.
•
Wire strip length to be connected to the quick-fit screwless terminal block must be 8 mm. If the strip length is longer
than 8 mm, the conductor will be exposed, causing electrical shock or short circuit between adjacent terminals. If
it is shorter, the conductor will not contact the connector.
•
Do not disassemble the product. Disassembly may result in electrical shock or equipment damage.
CAUTION
•
Installation and wiring must be performed by qualified personnel in accordance with all applicable safety
standards.
•
Installation must be carried out according to the operating conditions (power, temperature, humidity, vibration,
shock, installation position, atmospheric condition, etc) specified in this manual to prevent equipment damages.
•
All wiring must comply with local codes of indoor wiring and electric installation rules.
•
Install a circuit breaker or circuit protector in the power supply circuit that supplies the power to the product.
•
Use crimp terminal lugs with insulation for electric wires connected to the screw terminals.
•
Connect cables to the power source with terminals or the like for permanent connection.
•
Make sure all the wires are tightly connected to prevent heat generation or equipment damages.
•
If more than the rated power supply voltage is applied, product replacement is required for safety.
•
Install this product in a location out of reach of unauthorized people. (e.g. Inside of the control panel cabinet)
•
Lightening protection based on the regional characteristics and the building structure is needed to minimize
equipment damages.
•
Noise protection is necessary when the product is installed in a location close to many noise sources.
•
Do not block the vent holes of the product to prevent equipment damages. Remove protective sheet after
installation and wiring.
•
After mounting the product on DIN rail, make sure that the holding parts of all the modules are properly fixed with
their whole parts lifted. The product may drop from the DIN rail and be damaged due to improper mounting.
•
Dispose of the lithium battery in accordance with your local regulations.
•
Dispose of this product in accordance with your local regulations. Do not reuse all or a part of this product.
Trademark information:
Infilex, Neopanel, PARAMATRIX and savic-net are trademarks or registered trademarks of Azbil Corporation in Japan or in other countries.
BACnet is a registered trademark of American Society of Heating, Refrigerating and Air-Conditioning Engineers (ASHRAE).
CompactFlash is a U.S. registered trademark of SanDisk Corporation.
KPEV is a registered trademark of Furukawa Electric Co., Ltd.
LonTalk is a trademark of Echelon Corporation registered in the United States and other countries.