Setting up the unit
To make sure that you use this machine as intended, Ayra recommends to follow the steps described below.
Liquid
Before turning on the machine, make sure there is enough fog liquid in the tank. This machine is designed
and set for Ayra fog fluid. Proper fog liquid leaves less residue, is more efficient/economical and creates
almost odorless fog. The use of other fog fluids may cause fluid spraying or unpleasant fog odors.
The liquid tank of your WSM device has a volume of approximately 1,8 liters. Fill the tank for approximately
¾ of its capacity. Overfilling the tank may cause the liquid to spill during transport, because of shocks, impact
and tilting of the machine. Fluid consumption depends on the type of fluid, the amount of fog that you wish to
create and the time span of use.
Positioning
The WSM01 MKII fog machines is designed for use on a stable platform. It can be positioned on a floor, DJ-
booth or bar. However, Ayra does not recommend placing the machine near audience because of the high
temperature of the fog at short distance.
Control
The WSM fog machines are controllable in several ways. You are able to use the included wired remote, the
included wireless keychain remote or you can control the device with a DMX controller (not included).
Wired remote
Connect this controller with the 5-pin DIN connector on the rear of the machine.
1. Interval selection:
Determines the timespan when the machine is activated.
2. Duration selection:
Determines the duration if the timer activates the machine.
3. Output intensity:
Output 0-100% (variable)
4. Timer functionality on/off
5. Continuous fog:
Continuous operation with the selected output intensity
6. Manual fog:
Fog projection at the selected output intensity, when pressed
Yellow LED:
Timer function on/off
Red LED:
Continuous fog function on/off
Green LED:
Fog machine ready-indicator
Wireless keychain remote
The wireless keychain remote is compact and gives you flexibility. It operates under a range of max. 25
meters, if not obstructed by objects or walls.
To use the wireless keychain remote, connect the receiver to your fog machine using the correct connector.
The keychain has a protective cover, making it impossible to press buttons while you aren’t using the remote.
The cover slides down easily, granting access to the LED and buttons. When pressing a button, the LED will
be lit, indicating that a signal is being sent to the receiver.
The keychain remote has an expandable antenna to improve the range and signal transmission. To replace
the internal battery, remove the screws on the rear.
DMX control
When you are already in the possession of a DMX-controller, it is possible to integrate the WSM fog machine
in your light show. The output of the fog machine can be adjusted with one DMX channel, from 0 to 100%.
For optimal use of the fog machine on DMX, some basic knowledge is needed. Contact your local dealer for
more information.
Connect the fog machine to your DMX-controller, using standard XLR male to XLR female cables.
Select the correct DMX starting address by using the dipswitch panel.
All information and illustrations shown in this user manual are subject to change without further notice.
User manual version: 2.0
Creation date + author initials: 11-02-2014 RV Revision date + author initials: 16-06-2014 RV
