9
can be changed so the display will be active continuously. To prevent injury, damage and dangerous
situations, only perform actions on the display and menu-functions when the movinghead is in a static
position. To change the working mode of the fixture, disconnect and reconnect the power supply. The
device will re-activate itself and turn to the static 0-point position which gives you the opportunity to
change the working mode. In DMX-mode the display and buttons can be approached when using the
‘blackout’ mode of your DMX-controller or software.
When selecting an automatic or music controlled mode, press ‘enter’ to activate it. After this you have
some seconds time to remove your hand from the direct environment of the head, as it will activate the
sequence and start moving.
Navigation in the menu structure is easy. Use the
‘UP’
and
‘DOWN’
keys to navigate between the
several settings, use
‘SET/ESC’
to return to the previous category and use
‘ENTER’
to select a
submenu or to confirm certain settings.
When scrolling through the several functions of the ERO 101 in the menu structure, you will notice that
there are several settings to change. On the next page you will find an extensive description of all
functions and the several values which can be selected.
When activating the fixture and when the start-up process is completed, you will notice that the last
selected DMX-address is shown on the screen. (standard: 001). When no DMX-signal is received, the
display will blink continuously. It is possible to approach the menu when the fixture is in this particular
position.