Operation and Installation
To activate the device, it must first be connected to an active mains power point. Once connected, the device
will switch on automatically.
During the start-up process, ‘AYRA’ will be displayed on the integrated menu screen and the device cannot
be operated yet. Once the start-up process has been completed, the device will jump to the last used mode
and from here, the various settings and modes can now be adjusted using the display and menu buttons.
If a DMX signal is detected, the device will automatically jump to DMX mode and the last DMX address used.
With a brand new device, the automatic DMX address is usually 001. The DMX address can be set manually
using the display and menu buttons.
Using the display and menu buttons, all the various functions and parameters of the device can be adjusted.
Use the ‘Enter’ button to select a function or to confirm an adjustment. Use the ‘Up’ and ‘Down’ buttons to
change values and use the ‘Menu’ button to return to the menu. After a setting has been saved, press and
hold the ‘Menu’ button down for 2 seconds so that the device returns to operation mode and the settings just
saved. This should be done after the operation mode or DMX address has been changed but is not always
necessary since the device will automatically return to operation mode and the settings just saved within a
few seconds.
In the Menu, the following modes and functions can be found:
Display
Mode
Function
ADDR / A001
DMX address configuration
Address A001 … A512
CHAN
Channel mode selection
4CH / 6CH / 7CH / 18CH
MASL
Slave mode
Master
Slave
SHOW
Show sel speed
SH 0 – SH 15 (Show 0 = random)
speed S 00 – S 10
COLO
Colour macros with dimmer,
macro sel speed
DIM: 000-100
CO: 01 – 15 / JUMP / FADE
SPED: 000 - 010
MANU
Manual mode
STRO 0-100 (strobe effect, slow-fast)
DIMM 0-100 (master dimmer 0-100%)
RED 0-100 (dimmer red 0-100%)
GREE 0-100 (dimmer green 0-100%)
BLUE 0-100 (dimmer blue 0-100%)
WHIT 0-100 (dimmer white 0-100%)
SOUN
Sound controlled mode
Mode: ON / OFF
SENS
Sound sensitivity
0 - 99: sensitivity in %
LED
LED Display On/Off when not
active
ON/OFF
DISP
Display inversion
Display inversion, disp - dslp
TEST
Test mode
Test program that activates and checks each
LED colours 1 by 1
INFO
Fixture information (cannot be
adjusted by user)
HOUR: duration of use in hours
VER: firmware version
Below, you’ll find an explanation of each function:
ADDR:
With this function, you can determine the DMX start address of the device. Set it channel 001, and
the device will respond to DMX channel 1. Set it to channel 003, then the device will respond to DMX
channel 3 and so on.
CHAN:
This device can be operated using various DMX channel modes. If your DMX circuit is reasonably
full with devices and you do not need extensive control over the functions, a concise channel mode can be
The information included in this manual is subject to change at any time and without notice
Version: 1.0
Date and Author Initials: 17-02-2020 RV
Revision Date and Author Initials: -
