Operation and Mounting
To activate the device, plug it into a mains socket. Once it's connected to an active power source, it will turn
on automatically.
The device cannot be operated while it is still starting up and displays the ‘AYRA’ logo. Once the device has
fully started up, it will automatically jump to the last mode and setting. Operation modes and other settings
shown on the display can now be adjusted or changed via the menu buttons.
If a DMX signal is detected, the device shall automatically switch to DMX mode and the DMX address that
was last used. For a new device, this is usually DMX address 001. The DMX address can of course be
changed via the display and menu buttons.
The functions, modes and settings can be changed by using the display and menu buttons. Push ‘Enter’ to
select a function or to confirm a change. Push ‘Up’ and ‘Down’ to change any values and push the ‘Menu’
button to return to the main menu. A few seconds after confirming a setting by pressing ‘Enter’, the device
shall automatically return to the main menu and perform the set actions. This can be sped up by holding the
‘Menu’ button down for 2 seconds after confirming a setting by pressing ‘Enter’. This is usually necessary
after adjusting the operation mode or DMX address.
The Menu includes the following options and fuctions:
Display
Mode
Function
ADDR / A001
DMX Address Configuration
Address A001 … A510
SHOW
Show Mode 0-15
SH0-SH15 Built-in Shows
SH0 = Random sound reactive effects
SH1-15 = Show selection
NASL
Slave Mode
Master
Slave
SOUND
Sound-Controlled Mode
Modus: ON / OFF
SENS
Sound Sensitivity
0 - 100: Sensitivity in %
NANU
Manual Mode
Dimm: LED Intensity 0-255
Colo: Colour-indexing and rotation speed
VaVe: Rotation direct (anti-clockwise or
clockwise) 000-255
LED
LED Display On / Off when not in
use
ON: Display always on
OFF: Display off when not in use
DISP
Display Invert
ON / OFF
TEST
Test Mode
Test programme that runs the device through all
functions to check calibration and for
malfunctions
TEMP
Temperature Display in Degrees
Celsius
Displayed in Degrees Celsius
FHRS
Duration of use
Displayed in hours
VER
Firmware Version
Displays current version of firmware installed.
This cannot be adjusted or changed
RST
Reset device (selecting ‘Yes’ will
cause a complete reset)
Yes / No
An explanation of all available functions can be found below:
The information in this user manual is subject to change at any time without notice.
Version: 1.0
Date of creation and author's initials:07-10-2019 RV
Revision date and author's initials: -