Installation and connection requirements
Now that you know how the TDC 180 Derby works, it's important to know how to use it correctly and safely,
according to the installation and connection requirements.
Make sure the device and connection cables are out of reach of children, and that if children are present,
they are under adult supervision at all times. Because this device can be used upright or suspended, children
could pull on the cables, causing the device to fall on top of them. To avoid injury, it is important to pay close
attention to the position and/or installation of this device.
Upright use
Should you want to use the TDC 180 Derby in an upright position, make sure it's on a flat, stable surface like
a table, DJ booth or bar.
Suspended use (brackets)
Should you want to suspend it, use the mounting bracket located on the top of the device.
The armature is already fitted with a hanging bracket, including a hole to mount a standard G-hook or clamp.
You can find standard hooks and/or brackets for 35 or 50mm tubes (truss or light stand) at your local dealer.
Hardware for mounting the TDC 180 Derby 180 to a wall, ceiling, or beam is not included. Contact a
specialist if you're not surewhich hardware is required for your situation. A wooden beam and stone wall
require different mounting methods.
Should you want to suspend the TDC 180 Derby, you will need to attach a safety cable to the armature. This
is not included, but is available at your local dealer. The TDC 180 Derby is equipped with an eyelet for
hooking a safety cable. Once it's hooked on, you can wrap the cable around the truss or light stand and
attach it again by means of the same hook. This ensures the device is secured and prevents it from falling,
even if one or both of the brackets should come loose.
Ensure that the safety cable has a load capacity of 10x the weight of the armature and that the device can
not fall farther than 30 cm. You can wrap the safety cable around the truss or light stand several times to
ensure the fall is as short as possible. The shorter the fall, the less chance of damage or injury.
Light source
The TDC 180 Derby contains powerful LED modules that create an even more powerful effect thanks to a
special lens that bundles the beams together. Never look directly into the lens from at close range, as the
human eye can't adjust to the sudden intensity of the beam of light this device produces. It won't result in
permanent damage, but it can cause temporary blind spots, which may cause disorientation and discomfort.
Cooling
The TDC 180 Derby is cooled by a fan that is installed in the housing. It is activated when the device turns
on. Make sure the fan and ventilation slots are not blocked and regularly check that they are functioning
normally. Be aware that should the fan suck in substances like dust, smoke and moisture, this may impair its
operation.
Parts and repair
This product does not include spare parts and can not be repaired by the user. All inspections and overall
maintenance should be done by a specialist.
Cleaning and maintenance
Clean the exterior of this device monthly with a dry, or slightly damp microfibre cloth. Ensure that the device
is unplugged before cleaning it.
Check if all the screws are intact and secured and tighten or replace them where needed. Check all metal
parts of the device for any signs of corrosion. If corrosion is found, the device needs to be checked
thoroughly.
The information in this user manual is subject to change at any time without notice.
Version: 1.0
Date of creation and author's initials:18-02-2017 RV
Revision date and author's initials: -
