Operation and mounting
To activate the device, plug it into a mains socket. Once it's connected to an active power source, it will turn
on automatically.
During calibration, ‘AYRA’ will be shown on the display, which means the device is not ready to be operated.
Once the device has fully started up, it will jump to the last-used mode. Operation modes and other settings
shown on the display can now be adjusted or changed by means of the menu buttons.
Should the device detect a DMX signal, it will automatically switch to DMX mode and will display the last-
used address. For new devices, this will normally be DMX address 001. Of course, you can change the DMX
address via the display using the menu buttons.
Using the display and the menu buttons, you can adjust the functions and settings of the device. Press
'Enter' to confirm an adjustment or select a function, use ‘Up’ and ‘Down’ to change amounts and ‘Menu’ to
go back to the menu. By holding the ‘Menu’ button down for 2 seconds after saving a specific setting, the
device will return to operation mode and adopt the setting. This will also be done after any changes in the
operation mode or DMX address. This operation is not always necessary, considering the device
automatically does this after a new setting is confirmed.
The menu contains the following options and functions
display
Mode
Function
ADDR / A001
DMX address configuration
Address A001 … A512
SLND
Slave mode
Master - NAST
Slave 1 – SL 1
Slave 2 – SL 2
SHND
Automatic mode
SHND – automatic mode based on microphone
AUTO – automatic mode. Select speed 0-9 by
pressing ‘Enter’
SOUND
Sound-controlled mode
Mode: ON / OFF
SENE
Sound sensitivity
00 - 99: sensitivity in %
BLND
Blackout without DMX
YES: Blackout mode will activate in case of DMX
or clave signal loss
NO: Switch to automatic or sound-controlled
mode in case of DMX signal loss
LED
LED Display on/off when not in
use
ON/OFF
DISP
Display inversion
Display inversion, Idsp-dspI
TEST
Test mode
The test program runs through each LED colour
one by one to check they are all functioning
correctly.
HOUR
Time registration
0000 – 9999 usage in hours
VERS
Firmware version number
Display of firmware version number (can not be
updated by user)
You'll find an explanation of the various functions below:
ADDR:
With this function, you can determine the DMX start address of the device. Set it channel 001, and
the device will respond from DMX channel 1. Set it to channel 003, then the device will respond from DMX
channel 3, etc.
SLND:
The Master-Slave mode is designed to sync multiple devices. A copy of the internal program is sent
to the daisy-chained devices so that each one projects the same effect. The master-slave function works by
means of standard 3-pin XLR cables. The only difference is that the first device in the chain does not receive
DMX input.
The information in this user manual is subject to change at any time without notice.
Version: 1.0
Date of creation and author's initials:18-02-2017 RV
Revision date and author's initials: -
