While doing so, a DMX-terminator must be connected to the last fixture, at the end of the DMX-chain. This
prevents reflections in the DMX-signal, which could cause flickering and unwanted behavior from your
intelligent fixtures.
A DMX terminator is a XLR connector with a resistor of 120 Ohm, placed between pin 2 and 3 as a bridge.
In DMX-mode you are able to control every feature of this fixture by using the following channel settings:
DMX Channels
Channel Value
Function
CH1
0
The right motor move clockwise
1-200
Motor (0º-360º)
201-255
The right motor move counter-clockwise
CH2
0
The left motor move clockwise
1-200
Motor (0º-360º)
201-255
The left motor move counter-clockwise
CH3
0-----255
speed of motor(from fast to slow)
CH4
0-----255
Gobo change of the right scan head
CH5
0-----255
Gobo change of the left scan head
CH6
0-----255
Gobo rotation speed
Any information and illustrations shown in this user manual are subject to change without further notice.
User manual version: 3.0
Creation date + author initials: 21-11-2013 RV Revision date + author initials: 25-11-2014 RV
