Ayce 7613164540966, Operator'S Manual

Page: 42 / 48

GB
| 82 83
180814_ayce_NC200ES_IM 180814_ayce_NC200ES_IM
4. To remove the sanding paper, peel it away from the base.
5. Ordinary (non Hook & Loop type) sanding paper can also be used.
6. Release the sandpaper clamp from both sides of the sander.
7. Insert the end of the sandpaper under one clamp and pull the paper tight over
the base ensuring the holes align with those in the base and then clamp the
other side.
8. The sanding paper should be kept tightly clamped over the base, otherwise
there could be excessive wear of the base material.
WARNING
!
Do not continue to use the sander with a sanding paper that is over
worn or damaged.
WARNING
!
Do not use the same sanding paper for wood and metal. Metal particles
become embedded in the sanding paper and will scour a wooden sur-
face.
WARNING
!
Take care to regularly clean out the buildup of dust on the base under-
neath the sanding paper and not to let the sanding paper wear com-
pletely down before replacing it. Failure to observe these two precau-
tionary measures can lead to damage to the hooks and loops on the
base and the sanding paper will not attach properly.
NOTE : Hook and loop sanding base is not a warranty item.
c. Selecting the speed (Fig.2)
Fig. 2
• With the speed controller, the rate of
oscillation can be selected (also
during operation). Rotate the speed
controller to choose the suitable
speed.
• The optimum speed depends on the
material and should be determined by
carrying out a practical test.
• Stage 1: slow Stage 6: quick
d. Mounting the dust extraction (Fig.3)
WARNING
!
Always connect the dust extraction when sanding.
Fig. 3
• Inhalation of dust particles can be
detrimental to health.
• To install the dust extraction bag,
aimed at the grooves on the dust
extraction port and then insert the
bag into the port.
• Rotate the dust extraction bag
clockwise for locking.
• For efficient operation, always empty
the dust extraction bag
• Dust extraction tube is also provided.
• To install the dust extraction tube,
aimed at the grooves on the dust
extraction port and then insert the
tube into the port.
• Rotate the tube clockwise for locking.
• A dust extraction system or a suitable
vacuum cleaner is allowed to be
connected to the tube for enhancing
the dust efficiency.
• Always keep the dust extraction
holes in the sanding base free of
obstructions.
e. Switch on and off (Fig.4)
Fig. 4
• Hold the tool firmly to control the
twisting of the tool.
• To prolong the life of the tool never
overload it.
• To turn the sander on, push the O/I
switch forward.
• To stop the sander, push the O/I
switch backward.
NOTE. Always lift the sander from the work
before switching on or switch off.