3.Environmental protection
- Dispose of soiled maintenance material and operating materials at the appropriate
collection point.
- Recycle packaging material, metal and plastics.
4.Connecting to earth
The housing is allowed to be connected to earth in order to discharge static electricity.
To do this, connect one end of a cable to the earth terminal (17) on the generator and the
other end to an external earth (for example an earthling rod).
OPERATION
NOTE: The generator has been shipped without engine oil. fill with oil or it will not
start.
1. Start the engine
NOTE: Do not connect the electric load or equipment before starting the engine.
- Open the fuel tap (10) by turning it down.
- Start the engine with the grip of recoil starter (3) by pulling the handle forcefully. If the
engine does not start, pull the handle again.
- Push the choke (2) back again after the engine has started.
IMPORTANT!
When starting with the pull cord, the motor may recoil suddenly as it starts up, resulting
in hand injuries. Wear protective gloves when starting the equipment.
WARNING: Once the generator has started, release the starting handle slowly to
avoid injury/damage as it whips back.
2.Connecting Electric Devices
AC application
a) Ensure that electrical equipment is switched off before connecting to the generator.
b) Connect the plug of the electrical equipment into the appropriate socket.
c) The generator can supply 230 V AC.
12V DC application
a) Set DC overload Rest (12) to “ON”
b) Connect the DC cable to the DC output.
c) Clamp the red wire to the positive (+) terminal and the black wire to the negative (-)
terminal of the equipment you would like to use.
d) If the DC overload protector activates, wait for a few minutes and then press the DC
breaker shown on right.
- Move the engine ON/OFF switch (11) to position "I”.
- Move the choke (2) to position IØI (if the engine has warmed up, then ignore this step).
GB
83
|
84
GB