AYC GROUP LLC
| Page
10
of 12
Spa Tub Operation & Maintenance
Filling Water
-
Place the drain plug into the drain from the top (the drain plug may need to be adjusted so that it forms a tight
seal around the drain).
-
Close the drain plug by turning the drain knob counterclockwise.
-
Lift the single lever hot/cold mixer faucet to fill the tub to the water level above the whirlpool jet at least 1 inch.
Fill the tub until the pipeless jet is completely submerged in water
-
If the water level decreases during the operation of the whirlpool, simply add more water.
-
Warning:
DO NOT RUN DRY. BASIN MUST FILLED WITH WATER TO LEVEL INDICATOR.
Starting Whirlpool
-
Make sure magnet jet head is well attached to the jet motor
-
Press the whirlpool jet button located on the right side of the front panel to turn on and off.
Draining
-
Turn the drain knob clockwise to open the drain plug to drain out water.
Warning
: Do NOT spin the drain gear too much, or it would strip and be ruined.
-
Press the drain button located on the left side of the front panel to turn on/off the discharge pump (if unit is
equipped with one).
Warning:
Do NOT turn on the drain pump unless adequate water is in the tub. THE WARRANTY IS VOID IF THE
PUMP HAS BEEN RUNNING DRY.
Maintenance
-
When finished with client, do not remove magnetic jet until motor is fully stopped. When motor is fully
stopped, remove magnetic jet head from the motor and remove jet cover and impeller for sanitization by
turning counterclockwise.
-
At the end of the day, flush the whirlpool system with low-sudsing detergent and warm OR and EPA
–
registered
cleanser for 10 minutes. Rinse with clean fresh water and drain.
-
Note
: The use of oil-based products can build up in the jet system and build up onto the surface of the basin.
Daily cleaning will minimize build up.
