AYC GROUP LLC
| Page
7
of 12
Pedicure Chair Installation
These steps must be followed in order for the installation to be successful. You will require a helper for steps 2-9.
The estimated time is about 15 minutes.
Step 1:
Locate the four holes on your pedicure spa base and align the two metal bar spacers (the black metal bars with
holes on each end) with the holes going lengthwise along the base, not across.
Step 2:
The rest of the steps will require a helper - Set the chair directly on top of the metal spacer bars carefully.
Step 3:
While one person is supporting the chair on the metal spacer bars, attach the power cord to the back of the chair
and plug it into the wall outlet (If you would like to minimize wires, you can plug the chair into the control box outlet
labeled “continuous”
and then plug the control box power cord to the wall outlet)
Step 4:
Connect the remote control to the chair. To do this, you need to pull the remote cable around the back of the
chair and plug it into the connector that is sticking out from the seat frame. Make sure the pins line up and then screw
in the removable washer to secure the connection.
Step 5:
Use the remote to move the seat backwards via the button; This will allow access to the holes in the front. Once
you can access these holes, make sure they are lined up with the holes in the metal spacer bars and base.
Step 6:
Insert the screws with the washers on them through the holes on the frame of the chair, through the metal
spacer bars and base.
Step 7:
After that, move the chair forward using the remote to allow access to the holes in the rear of the base. Make
sure that these are lined up with the chair frame and the metal spacer bar as well.
Step 8:
Insert the screws with the washers on them through the holes on the frame of the chair, through the metal
spacer bars and base.
Step 9:
Go to the rear of the base and reach in through the access panel to attach the nuts to the end of the bolts from
steps 6 and 8. Tighten the nuts with a wrench while your helper holds the chair down and in place.
Step 10
: Your helper can now relax. Attach the black wooden board to the seat frame. Remove the screw caps on the
wooden board and make sure the connecting piece underneath the wooden board is interlocking with the small
horizontal bar above the motor. Align the 2 screws in the front and attach the caps back on to secure the board.
Step 11:
Connect seat vibration wire. Pull out the connecting wire from the seat frame and connect it to wire under the
seat cushion.
Step 12:
Attach the back cushion, seat cushion and skirt to the chair.
Step 13:
Attach the footrest on the spa base. Align the holes on the footrest to the existing holes on the base and install
the six screws.
