3
2-
Electrical Connections
2.
1 Connect the CANBUS cable terminals of the LOPs to the corresponding socket on the
control panel. (100-1000-CL1-CH1).
2.2
If your system has a pit control unit with CAN interface as shown in Figure 4, connect
all LOPs to this unit wth CAN-BUS cables with dual white rectangular sockets.
2.3
If there is no electronic pit control card with serial communication, connect the LOP
on the lowest floor as shown in Figure 5 and complete the process.
3- Operation and Setting Procedures
Select the display you have used for display settings from EK04 and follow the
instructions.
After completing the settings, close the top cover of the LOP.
Figure 4
Figure 5
