10 mm
10 mm
10 mm
-39-
Water Connection
WARNING!
3 mm
3 mm
Cold Water Connection
Improper connection of the equipment earthing conductor can result in the risk of an electric shock.
Check with a qualified electrician or service representative if you are in doubt whether the appliance is properly
earthed.
Do not modify the plug provided with the appliance. If the plug does not fit properly to the outlet, please have
a qualified electrician to install a proper outlet.
10 mm
WARNING!
10 mm
GROUNDING INSTRUCTIONS
This appliance must be earthed. In the event of a malfunction or breakdown, earthing will reduce the risk of electric shock
by providing a path of least resistance for the electric current. This appliance is equipped witha cord having an equipment-
earthing conductor and an earthing plug. The plug must be plugged into an appropriate outlet that is installed and earthed
in accordance with all local standards and requirements.
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure
that it is fastened tightly in place. If the water pipes are new or have not been used for
an extended period of time, let the water run to make sure that the water is clear and
free of impurities. If this precaution is not taken, there is a risk that the water inlet can
get blocked and damage the appliance.
please close the hydrant after using.
Connection of drain hoses
Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it run into the sink, making sure to
avoid bending or crimping it. Use the specialplastic support that comes with the appliance. The free end of the
hose must be at a height lower than75cm and must not be immersed in water to avoid the back flow of it.
The special plastic hose support must be solidly fastened to the wall to prevent the drain hose from moving and
allowing water to spill outside the drain.
10 mm
Attention:
10 mm