3
REV. 2/4/2020 INSTAXADBXH-CH1
CONNECTIONS TO BE MADE
Attention!
This interface will work with models that are either non-amplified, or amplified. Please follow
the instructions carefully for your model vehicle. Failure to do so will result in either no sound, or low
sound. If you are unsure if your vehicle is factory amplified or not, please contact your local dealership.
For models
without
an amplifier:
From the 16-pin harness with stripped leads to the aftermarket radio (harness included with interface):
• Connect the
Red
wire to the accessory wire.
Note:
If installing an AXSWC (sold separately), connect the
Red
wire on the AXADBXH-CH1
harness as well.
• If the aftermarket radio has an illumination wire, connect the
Orange/White
wire to it.
Attention!
The following (4) wires are reversed on purpose. These wires will not match “color
code” to the aftermarket radio.
• Connect the
Gray
wire to the right rear positive speaker output.
• Connect the
Gray/Black
wire to the right rear negative speaker output.
• Connect the
White
wire to the left rear positive speaker output.
• Connect the
White/Black
wire to the left rear negative speaker output.
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the
Blue/Pink
wire to the VSS/speed sense wire.
• Connect the
Green/Purple
wire to the reverse wire.
• Connect the
Light Green
wire to the parking brake wire
• Tape off and disregard the following (6) wires, they will not be used in this application:
Blue/White
,
Brown
,
Green
,
Green/Black
,
Purple
,
Purple/Black
From the AXADBXH-CH1 harness to the aftermarket radio:
• Connect the
Black
wire to the ground wire.
• Connect the
Yellow
wire to the battery wire.
• If installing an AXSWC (sold separately), connect the
Red
wire to accessory power.
• Connect the
Blue/White
wire to the power antenna wire.
• Ensure the (2) 4-pin Molex connectors (with
green
and
purple
wires) are connected together.
• Connect the
4-pin harness with stripped leads
, to the 4-pin Molex connector
(with
gray
and
white
wires).
Attention!
The following (4) wires are reversed on purpose. These wires will not match “color
code” to the aftermarket radio.
• Connect the
Green
wire to the right front positive speaker output.
• Connect the
Green/Black
wire to the right front negative speaker output.
• Connect the
Purple
wire to the left front positive speaker output.
• Connect the
Purple/Black
wire to the left front negative speaker output.
12-pin pre-wired AXSWC harness:
This harness is to be used along with the optional AXSWC (sold separately) to retain steering
wheel audio controls. If the AXSWC is not being used, disregard this harness. If the AXSWC
will be used, please refer to the AXSWC instructions for radio connections and programming.
Disregard the harness that comes with the AXSWC.
Continue to Installing & Programming the AXADBXH-CH1
