5
REV. 5/3/2018 INSTAX-ADDCAM
CONFIGURING THE AX-ADDCAM
(CONT.)
INSTALLING THE AX-ADDCAM
With the key in the off position:
• Connect the AX-ADDCAM harness into the interface, and then to the “Plug & Play” harness
(sold separately).
• Connect the “Plug & Play” harness (sold separately) to the wiring harness in the vehicle.
Note:
If the “Plug & Play” harness (sold separately) includes any secondary harnesses, connect
those as well.
• Connect the cameras to the appropriate RCA jacks.
Video trigger description
•
Backup camera:
Dedicated by default to Video Trigger 1. Will activate the backup camera
while the vehicle is in reverse.
•
Left blinker:
Activation of the left turn signal will activate the left camera. *
•
Right blinker:
Activation of the right turn signal will activate the right camera. *
•
Auto (reverse -> drive):
Available only for Video Trigger 4, when installing a front camera. With
this feature selected, the camera will activate automatically once a reverse-then-drive sequence
is seen from the vehicle. Example of this scenario would be while parallel parking the vehicle. As
an alternative, a control wire can be used instead to manually activate the camera
.
Note:
Auto (Reverse -> Drive) will disable the camera once 15 MPH is reached. A control wire
activated will also disable the camera.
Note:
If the control wire is activated while driving, the camera will activate and deactivate
during stop-and-go traffic.
•
Control 1-4 (positive or negative) trigger activation wires:
Can be used as a positive or
negative trigger to manually activate a camera via a toggle switch, or similar device.
* Not available for Fords with a 4-inch display screen radio.
VSS out Function
• Disable:
On by default.
• Camera Active:
Active while camera is on.
Other settings
Switched 12V with
• Disable:
On by default.
• Accessory Out:
12-volt out when
CAN data is detected.
• Camera Active:
12-volt out if a camera
has been activated.
