CAUTION!
All accessories, switches, climate
controls panels, and especially air bag indicator
lights must be connected before cycling the
ignition. Also, do not remove the factory radio
with the key in the on position, or while the
vehicle is running.
AX-ADDCAM
I N S TA L L AT I O N I N S T R U C T I O N S
AxxessInterfaces.com
© COPYRIGHT 2018 METRA ELECTRONICS CORPORATION
REV. 5/3/18 INSTAX-ADDCAM
INTERFACE FEATURES
TOOLS REQUIRED
INTERFACE COMPONENTS
TABLE OF CONTENTS
Introduction............................................................2
Connections to be made .......................................2
Configuring the AX-ADDCAM ............................. 3-5
Installing the AX-ADDCAM .....................................5
Programming the AX-ADDCAM .............................6
Connector pin-out (20-pin) ..................................7
AX-ADDCAM
• (4) Camera inputs
• Programmable 12V 5-amp switched output (configured through the Axxess Updater program)
• Reverse signal trigger generated via CAN bus communication of the vehicle
• Turn signal trigger generated via CAN bus communication of the vehicle
• (4) Programmable camera control wires (configured through the Axxess Updater program)
• Can also be manually controlled, and used along with an aftermarket radio
• VSS (Vehicle Speed Sense) input and output
• Micro “B” USB updatable
• Wire cutter • Crimp tool • Solder gun • Tape
• Connectors (example: butt-connectors, bell caps, etc.)
• AX-ADDCAM interface
• AX-ADDCAM harness
