Maintenance
19
Fig 35-36
Fig 33-34
Head Stock Adjustment
If there is sufficient play happening in the head stock
assembly, loosen the three locking Hex bolts (E) to the right side
of the head stock column and carefully adjust the three gib strip
screws (F), see figs 35-36.
NOTE: make small adjustments, pulling the operating
lever down until the head stock slides smoothly up and down
the column, but not too much causing the head stock to tighten
or jam.
When you feel the slide play has been eliminated, tighten the
three locking Hex bolts (E) on the column to secure the setting.
D
C
F
E
General Maintenance
WARNING!! DISCONNECT THE MORTICER FROM
THE MAINS SUPPLY BEFORE CONTINUING!
To ensure optimum performance from your morticer routine
cleaning and lubrication is required.
After long periods of use wood and resin deposits will build up
on the table and the rack and pinion gears. Clean all surfaces
using “Axcaliber Blade and Bit Cleaner Code 951145” then apply
a light application of lubricant to all moving parts using
“Axcaliber Dry Lubricant Code 503468”.
Continues Over....
Code: 951145
Code: 503468
Locking Hex bolts
Gib strip screws
