Setting Up the Morticer
15
The table camp can be adjusted to accommodate different
sizes of timber using the pre-drilled holes in the table. Using
a spanner remove the two bolts and washers and place safely
aside. Re position the clamp assembly to the desired position
and replace the two bolts and washers and tighten, see figs
19-20-21.
Table Clamp
Adjusting the Table
Fig 19-20-21
The work table can be adjusted from back to front and from left
to right by the operating the, main control wheel to the front of
the morticer.
Left to Right Movement
Push the operating wheel forward to engage the drive gear into
the table rack thus enabling the table to move from left to right,
see figs 22-23-24.
Fig 22-23-24
Continues Over....
Gear meshed with table rack
Position 1
Position 2
Position 3
Bolt/washer
