Assembly
13
18. Locate the two filter bags (11) and filter bag retaining belts
(9). Open up one of the filter bags, hook the bag onto the steel
hooks around the collector (12) to temporarily hold the bag in
place, see fig 41.
19. Rap one of the retaining belts (9) around the bag making
sure the belt is settled evenly around the base of the collec-
tor. Latch the retaining belt down to hold and to seal the bag
against the collector assembly, see figs 42-43.
20. Repeat steps 15-19 for the other dust collector assembly.
Fig 41-42-43
11
9
Bag hook
21. Put to hand one of the wide foam seal bands (17), peel back
the paper backing, position the end of band up against the
underside of the upper lip on the extractor housing and firmly
press down to secure in place. Carefully peel back the backing
guiding the seal band round the extractor until it overlaps
using a pair of scissors cut off any excess, see figs 44-45-46.
22. Go around pressing down the band to make sure it’s stuck
firmly down. Repeat step 21 for the remaining seal band.
23. Locate the two filter cartridge units (14) and shaker paddle
handles (15) insert the handle mounting over the paddle drive
shafts making sure the clamping bolt is positioned over the
machined face then tighten the bolts using a spanner to secure
the handles in position, see figs 47-48.
Fig 44-45-46
Upper lip
17
Fig 47-48
Machined face
15
Bolt
Spanner
Continues Over....
