Step 17 .
Place the upper dust drum (R) onto the lower dust drum (Q) as shown, with suction pips on
bottom drum opposite Window of top drum. Fit the big round clamp (H).
Fix the Round Clamp by 1/4”*4” L Hex Screw and Nut.
When fitting top drum half on top of bottom base
centralize it the best you can then fit clamp and tighten it
progressively while lightly tapping on the clamp ring with
a soft face hammer around the outside.
Step 18.
Fit Handle (K) to Drum (R) using 2 off
¼
” x
¾
” long Truss head bolt as shown, with
Washer and nut fitted on inside.
Step 19.
Install the 3 x Quick release Clamps on the drum,(W)
Fit the Clamp on the screw holes of drum as shown.
Fix with M4 x 20mm Phil. HD Screws and locks Nut
inside the drum.
Adjust Nuts as shown to lift drum up higher.(Drum will
lift up and seal when machine is switched on)
10.
