Axminster SX4-DIGI, Original Instructions Manual

Page: 17 / 30

15
Bed surface finish 1.Wrong RPM or feed rate
2.Drilling cutter broken down or
wrong selection
1.Adjust for appropriate RPM and feed
rate
2.Change the cutter
The drill is hard
to move on the
slide 1.The slide is too try
2. The gig of Z is too tight
3.There are some scrap on the
slide
1.Fill some oil
2.Adjust screw
3.Clean the slide
The spindle can't
clamp the end mill 1.Choose the wrong end mill
2.The spindle is broken 1.Change the end mill
2.Check the spindle and change the
right spindle
T nuts cannot be
fixed 1.The T nuts is broken or wrong
2.The T nuts on the worktable
is broken
1.Change the T nuts
2.Change a worktable or use a good T
nuts