Axminster SX4-DIGI, Original Instructions Manual

Page: 12 / 30

10
OPERATE THE MACHINE
1、The machine must stopped when you fix the cutter or other tool.
2、Clean the inner of the spindle (MT4)and cutter, put the cutter into the
spindle nose, put in the stem and lock it.
3、You should clamp all the parts you want to process and then adjust to the
right position.
4、Loose the lock handle of column, swing the up-down handle to lower the
spindle.
5、Start the machine, adjust the speed, swing the multipurpose handle, and
then the machine can start to mill.
6、When you milling the work piece, please lock the spindle and headstock.
In order to prevent size change during the work, please lock the
longitudinal and lateral gag.
7
、When you change the drill chuck or mill chuck, loose the protective cover
and put it aside, then relative the screw, use the hammer to remove the
taper-shank from spindle, and then loose the stamp to change the drill chuck
or mill chuck.
After use the machine, please cut off the power, clean the bed and fill some
oil on the surface of the bed to prevent been rusted to keep beautiful and
function.
Gag adjustment