Axminster SIEG SC6, User Manual

Page: 5 / 50

INITIAL START SC6
Release the Emergency Stop Button (4) by
turning the knob head to right, the Digital
Readout Speed Display
(22) wlll come on.
Press the start button (21) , the spindle will be
forward turning; the speed is 100r/min. Press
the reverse button
(25) to turn the spindle in
the oppsite direction.
Press the Speed Up Button (2) to increase the
spindle speed or the Speed Down Button (24)
to decrease it.
If the lathe over-loads, for example, cutting too
much, just turn off the power by pressing the
stop button
(26) then switch it on again, by
pressing the Start Button (21) and increasing
the spindle speed as required.
Familiarise yourself with the lathe controls
shown in the figure below. Make sure the
Emergency Stop Button
(4) is pushed down
before continuing.
Turn the switch (6) to the left for the lathe
function. The power indicator (5) will light up.
NOTE if it does not light up, unplug the lathe
and check the fuse on the lathe and then the
plug. Call our technical sales department on
0330 100 0299 if you are still having problems.
2
24
21
4
5
22
23
25
26
6
6.
8.
, then refer to step (6 & 7).
Start
(9)
(11)
Mill Symbol Lathe Symbol
Press the Emergency Stop Button (4) to stop
the lathe instantly, the Digital Readout Speed
Display
(22) will go off. NOTE: If you lift up
the eyeshield (7) it will also stop the lathe.
If you have mounted the C6 Mill attachment
(Part No: 600870) to the lathe, turn the
selector
switch (6) to the right to transfer
power to the mill. NOTE: The lathe power
indicator
(5) will go out.
Press the Stop Button (26) to stop the lathe
spindle.
5