Axminster Trade 107644, Manual

Page: 15 / 36

SETUP/ADJUSTMENT
15
Lower Blade Guides
Loosen the locking knob (3), position the thrust bearing (4)
1mm behind the blade. Note: loosen the two cap head screws
(5) to the rear of the guide assembly and adjust, so the thrust
bearing is centred with the back of the blade, see fig see fig
18-19-20-21. Tighten the knob (3) to secure the setting.
Fig 18-19-20-21
3
4
5
Blade
Loosen the clamping knobs ( 2) and adjust the guide bearings
so they are approximately 0.5mm to the blade, see fig 22-23.
NOTE: A sheet of A4 of photocopy paper is approximately
0.5mm thick. Re-tighten knobs (2). Close the blade guide
access door (1).
Fig 22-23
2
Remove the table insert, see fig 24-25.
Fig 24-25
Insert spring latch
Table insert
Twist latch
Continues over...
0.5mm
1mm
2