Axminster Trade 107644, Manual

Page: 14 / 36

SETUP/ADJUSTMENT
14
Setting the Fence
To make sure the guide fence is at 90˚ to the table, line up the
guide fence with the edge of the table’s ‘T’ slot, see fig 13. If you
find that the fence is out of alignment follow the step below.
1. Secure the fence with the locking handle (A).
2. Loosen the four Hex screws (B) on the fence camp assembly
and adjust until correct. Tighten the locking rings (C) to secure
the setting, see fig 14.
Fig 13-14
Fig 11
B
A
‘T’ Slot
Upper Blade Guides
Open the blade guide access door (1). Loosen the locking knobs
(2), adjust the fore and aft position of the guide bearings so
they are approximately 2mm behind the gullets of the saw
blade, see fig 15-16-17. Tighten the knobs (2).
Fig 15-16-17
1
Access door clamp
Guide Bearing Assembly
Pull/Push
2mm
MOVE THE SELECTOR SWITCH
TO ‘BRAKE OFF’ POSITION
2
2
C
1
2
Fig 12
Hex screws
Scale
Pointer
When you are satisfied that the table is set correctly, check that
the pointer of the tilt scale reads zero, see fig 12.