Axminster Trade 101256, Original Instructions Manual

Page: 11 / 56

Initial Assembly
11
7. Place a straight edge across the tables as before, adjust
the table support leg (8) as described in step 5, until the
pressed steel table (11) is level with the cast iron table
(10), see fig 18. When they are both level clamp the
tables firmly together by tightening the four bolts
beneath the cast iron table, see fig 19-20.
Fig 18-19-20
Rip Fence
Put to hand the rip fence rail shaft (20), rip fence (21), rip
fence scale (24) and rip fence control assembly (2).
1. Locate the fence rail shaft (20), remove the end nut
from each of the threaded studs and place safely aside,
see fig 21.
Fig 21
Fig 22
Fig 23
4. Find the rip fence control assembly (2), the fence
assembly and fence clamping handles (7). Screw on both
handles to the fence control assembly (2), see fig 25-26.
Slide the control assembly (2) onto the fence rail shaft
(20), see fig 27.
Fig 25-26
11
24
0
11
20
0
Continues Over....
7
2
7
Fig 24
M8 bolt
Machined hole
M8 Washer/Nut
2. Remove the two Phillips screws one from the side of
the main saw table (0) and the other from the pressed
steel table (11), see fig 22.
3. Locate the rail rip fence scale (24), lineup the
pre-drilled holes in the scale with threaded holes in
both tables and secure using the Phillips screws you
removed earlier, see fig 23. Insert the threaded studs on
rail shaft (20) into the four machined holes to the side
of the tables, replace the nuts you removed earlier and
tighten the assembly, see fig 24.
11
20