ASSEMBLY
8
Fig 08
Fig 07
D
D
Fence rail “T” slot
Clamping lever
Step 4 Locate the angled bolt (K), screw the
threaded end of the bolt into the threaded hole to
the top of the bandsaw frame and, using the supplied
10mm spanner, tighten with the nut to lock the bolt
in position, see fig 09. Find the push stick (F) and
hook it onto the angled bolt (K), see fig 10.
Fig 09-10
Fig 11
F
K
Table “T” slot
E
E
Step 3 Locate the fence assembly (D). Lower the
fence over the table until the clamping lever
assembly slots into the fence rail’s “T” slot. NOTE:
Make sure the clamping hook to the rear of the
fence (D) has engaged over the rear of the table.
Twist the locking lever clockwise to adjust the
clamping tension.(two rotations should be adequate)
then press down the lever to lock the fence in
position, see figs 07-08.
Step 5 Locate the optional mitre fence assembly (E)
and slide it into the table’s “T” slot, see fig 11.
