Assembly
8
7
6
5
4
11
9
10
8
C
The fence is a two piece adjusting system.
Each fence is independently adjustable to
compensate for different cutting thick-
nesses. Place a steel straight edge across
both fences (C), loosen the fence advance
clamping handle (a) and adjust the fence
advancing knob/s (b). Adjust until both
are aligned, see fig 7. Nip-up the clamping
handle (a) to lock the setting.
Fence
clamping
knob
Slide the
fence over
the ‘T’ bolt
a
b
Make sure the fence is square to the work surface, place a 90°
square up against the fence and check it is perpendicular to
the work surface. If adjustment is required adjust the four grub
screws to the rear of the fence mounting plates, see fig 8. This
pivots the fence forward and aft. Adjust until correct, see fig
9-10.
Locate the guide assembly (D). Insert the guide arm through
the guide arm mounting bracket on the spindle guard
assembly (B). Note: align the guide arm angle bracket between
the mounting bracket and nip-up the clamping handle (c), see
fig 11-12-13-14.
Guide Assembly
D
Angle bracket
Grubscrew
Fenc
e
M
oun
ting P
la
te
G
rub scr
ew
s
