Axley 761-033, Operating Instructions Manual, Page: 87 / 89

ENGLISH
87
Grill
Regularly remove grease from the grill with a soft plastic or wooden scraper. It is not necessary to remove
all the fat from the grill. If necessary, clean with warm soapy water and a soft cloth or nylon dishbrush.
Remove the grill surfaces and burners before thorough cleaning. The gas controls and branch pipe must
not be immersed in water. Check that all burners are working properly after refitting.
Screw connections
Check all screw connections regularly, and tighten if necessary.
Storage
Store in a dry and cool place. Cover the burners with aluminium foil to prevent insects and other debris
accumulating in the burner ports. Disconnect the gas cylinder if the product is stored indoors. Do not store
gas cylinders indoors. Gas cylinders should always be stored outdoors, out of the reach of children, in a
dry, well ventilated place, and separated from any sources of heat.
TROUBLESHOOTING
Problem Possible cause Solution
The burner does
not light with the
lighter The battery needs charging Replace the AA battery (follow the assembly
instructions).
Wires or electrode covered
by scraps of food Clean the wires and/or electrode with alcohol.
Electrode and burner are wet Wipe dry with a cloth.
Electrode damaged
– sparks
if damaged
Replace the electrode.
Wire loose or disconnected. Connect the wire or replace the electrode/wire.
Wire short circuits (sparking
between lighter and
electrode) Replace the lighter wire/electrode.
Defective igniter Replace the lighter.
The burner does
not light with a
match No gas flow Check if the gas cylinder is empty. If the gas
cylinder is empty, replace or refill it, or read under
"Sudden drop in gas flow and flame height".
Connection nut and regulator
incorrectly connected Turn the nut a half to three quarters of a turn until it
stops. Only tighten by hand, do not use tools.
Gas blockage Clear the gas hose. Check that the hose is not bent
or twisted.
Spider's web or insect nest in
the burner pipe Clear the burner pipe.
Burner ports clogged or
blocked Clean the burner ports.
Sudden drop in
gas flow or
flame height Gas cylinder empty Replace or refill the gas cylinder.
Excessive flow, the safety
device may have tripped Turn the control knob to Off, wait 30 seconds and
light the grill. If the flames are still low, reset the
safety device by turning the control knob to Off and
close the gas valve. Disconnect the regulator. Turn
the control knob to HIGH and wait 1 minute. Turn
the control knob to Off, connect the regulator and
check the connections for leaks. Open the gas
valve slowly, wait 30 seconds and light the grill
according to the lighting instructions.
Irregular flame,
the flame does
not run along all
the burner Burner ports clogged or
blocked Clean the burner ports.