Installationsanleitung AXIbox 11K
EN211103
6
4.2.2 Ending the charging process
1.
Stop the charging process at the car. When the car is fully charged, charging will stop.
2.
Disconnect the charging plug from the vehicle and stow it in the wallbox.
4.3 Changing the operation mode
The change between the operating modes Plug & Play and operation with RFID card can only be carried out
by an electrician. The change that must be made to the internal electronics is described under
Fehler!
Verweisquelle konnte nicht gefunden werden.
.
4.4 Behaviour in the event of an error
In the event of a fault, switch off the associated building-side fuse of the charging system and thus
disconnect it from the power supply. Ensure that the fuse is not switched on again before rectifying the
fault. Contact a qualified electrician.
