Axis Q8414-LVS, Installation Manual, Page: 22 / 28

AXIS Q8414–LVS Network Camera
4. Fold the top of the camera assembly upwards until the camera assembly is pressed
against the entire rim in the back chassis opening.
Important
Adjust the cable slack so that the cables are not squeezed between the sides of the camera
assembly and the back chassis.
5. Attach the camera assembly to the back chassis using the screws (torque 2.5 Nm).
NO NO NOTICE TICE TICE
To prevent corruption of recordings, the SD card should be unmounted before it is ejected.
To unmount, go to
Setup > System Options > Storage > SD Card and click Unmount .
Install AXIS T8642 Mounting Kit A (sold separately)
This accessory kit contains an Ethernet Over Coax Adaptor that enables camera installers to keep
the legacy coax cabling when converting an analog system to digital. It delivers standard PoE and
centrally-sourced power with no new cables required.
1. Attach the angled BNC connector to the AXIS T8642 device.
2. Plug the network cable into the network connector on the AXIS T8642 device.
3. Guide the other end of the network cable through the cable tunnel to the back of the
camera assembly and plug the network cable into the network connector.
4. Guide the cable ties through the cable tunnels and attach the AXIS T8642 device to
the camera assembly.
22