Axis Q8414-LVS, Installation Manual, Page: 17 / 28

AXIS Q8414–LVS Network Camera
2
Cable gasket, I/O
3
Screw (not included)
4
Washer
5
Gasket
3. Drill holes for the screws in the ceiling and in the walls.
4. Plug the gaskets back it into their holes. The gaskets should fit snugly with no folds
or bends.
5. Remove the network cable gasket from the back hole and route the network cable
through this back hole.
6. If applicable: Remove the I/O cable gasket from the back hole and route the I/O cable
through this back hole.
7. Pull the tab on the cable gasket to open it.
8. Attach the AXIS Connector Guard A on top of the RJ45 network connector. Drag the
network cable gasket along the cable and plug the network cable gasket into its hole.
The gasket should fit snugly with no folds or bends.
9. Remove the AXIS Connector Guard A from the top of the RJ45 network connector.
10. If applicable: Pull the I/O cable through the I/O cable gasket before attaching the I/O
connector to the cable. Plug the I/O cable gasket into its hole. The gasket should fit
snugly with no folds or bends.
11. Attach the back chassis to the corner in the wall using screws appropriate for the wall
and ceiling material. The screws should go through the washers and the gaskets to
secure the IP66 sealing.
17