40
AXIS Q6034-E - About
Plain Config
Plain Config is for the advanced user with experience of Axis network camera configuration. All parameters can be set and
modified from this page. Help is available from the standard help pages.
About
Here you can find basic information about your network camera. You can also view third party software licenses.
Resetting to the Factory Default Settings
To reset the camera to the original factory default settings, go to the
System Options > Maintenance
web page (as described
in
Maintenance,
on page 38). Alternatively, use the
Control button
and the
Power button
on the side of the camera as
described below:
Using the Control button and the Power button
This will reset all parameters, including the IP address, to the Factory Default settings:
1. Remove the dome ring and dome cover, this will automatically disconnect power from the camera.
2. Press and hold the Control button and the Power button at the same time.
3. Continue to hold down the Control button and the Power button until the Status indicator flashes amber (this may take
up to 15 seconds).
4. Release the Control button. When the Status indicator changes to green (which may take up to 1 minute) the process is
complete and the camera has been reset. The unit now has the default IP address 192.168.0.90
Note:
The Status indicator will display green for 10 seconds only. After that it will be unlit. Refer to the Status indicator
table on page 6 for more information.
5. Release the Power button.
6. Replace the dome ring and dome cover, this will automatically reconnect power to the camera.
7. Re-assign the IP address, see the Installation Guide for instructions.
