Axis P5534 Outdoor T95A00 Kit, Installation Manual, Page: 13 / 28

AXIS P5534 Outdoor T95A Kit Page 13
EN
GLIS
H
Complete the installation
1. Check that all cables and wires in the housing are properly connected.
2. Replace the top cover of the housing and tighten the screws using the supplied Allen key.
3. Connect the AXIS T95A housing to the power supply (110-240 VAC or 24 VAC - depending on
the version you are using).
4. Follow the instructions in Assign an IP address , on page 18, and Set the password , on page 21,
to install the camera on the network.
The installation is now complete.
Note:
Do not forget to place the desiccant salt bag into the housing before replacing the top
cover.
Remove the sunshield
Remove the three screws on the side of the sunshield with a Phillips screw driver; remove the screw
on the top center of the cover plate with the 4 mm Allen key.
It is recommended that this is done after the installation.