39
AXIS P5532-E/P5534-E - About
Plain Config
Plain Config is for the advanced user with experience of Axis network camera configuration. All parameters can be set and
modified from this page. Help is available from the standard help pages.
About
Here you can find basic information about your network camera. You can also view third party software licenses.
Resetting to the Factory Default Settings
To reset the camera to the original factory default settings, go to the
System Options > Maintenance
web page (as described
in
Maintenance,
on page 37). Alternatively, use the
Control button
and the
Power switch
on the side of the camera as
described below:
Using the control and restart buttons
This will reset all parameters, including the IP address, to the Factory Default settings:
1. Remove the top cover, for instructions please refer to the Installation Guide supplied with the camera.
2. Press and hold the control and restart buttons at the same time.
3. Release the restart button but continue to hold down the control button.
4. Continue to hold down the control button until the status indicator flashes amber at regular intervals (this may take
up to 15 seconds).
5. Release the control button.
6. When the Status indicator changes to green (which may take up to 1 minute), the process is complete and the camera
has been reset. The unit now has the default IP address 192.168.0.90
7. Replace the top cover.
8. Re-assign the IP address, see the Installation Guide for instructions.