AXIS
66583
REV: 2
COMMUNICATIONS AB
MANUAL RE-PAINT INST AXIS P551X/-E
DATE:
2016-04-07
Author: Sven Svensson
PAGE:
3(23)
- 3 -
2 Introduction
This document describes the way to operate when Re-painting a P551X / -E Network Dome
Camera. Any attempt to carry out a Re-painting operation on the camera, should only be
made after reading this document thoroughly.
To prevent damage to sensitive components, proper ESD protection must be carried out
while handling of the parts is only allowed in dust free environment.
3 Influence on Warranty and Product performance
3.1 Product Warranty
Any aftermarket modifications, which are not approved by Axis Communications AB, made
on Axis Network Dome cameras will void the Product warranty. Therefore, please note that
any deviation from the re-paint instructions described in this document will void the Product
warranty.
3.2 Product Performance
Axis Communications AB will only guarantee the product specifications and performance of
the camera in its original form.
4 Tools Required
Torx Screwdriver, (T8, T10, T20)
Screwdriver Flat > 6 mm width
Carton box min 190x190x140 mm
Knife for cutting in carton
