
AXIS P3367-VE Network Camera
Technical specifications
•
Connecting to an AXIS Video Hosting System service. See
. To connect, press and hold the button for about 3
seconds until the Status LED flashes green.
•
Connecting to AXIS Internet Dynamic DNS Service. See
. To connect, press and hold the button for about 3 seconds.
Connectors
Network connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
NO
NO
NOTICE
TICE
TICE
Due to local regulations or the environmental and electrical conditions in which the product is to be used, a shielded network
cable (STP) may be appropriate or required. All cables connecting the product to the network and that are routed outdoors
or in demanding electrical environments shall be intended for their specific use. Make sure that the network devices are
installed in accordance with the manufacturer’s instructions. For information about regulatory requirements, see the
Installation Guide available at
www.axis.com
Audio connector
The Axis product has the following audio connectors:
•
Audio in (pink)
– 3.5 mm input for a mono microphone, or a line-in mono signal.
•
Audio out (green)
– 3.5 mm output for audio (line level) that can be connected to a public address (PA) system or an
active speaker with a built-in amplifier. A stereo connector must be used for audio out.
For audio in, the left channel is used from a stereo signal.
3.5 mm audio connectors
(stereo)
1 Tip
2 Ring
3 Sleeve
Audio Input
Microphone/Line in
Ground
Audio Output
Line out, mono (stereo connector
compatible)
Line out, mono (stereo connector
compatible)
Ground
About I/O connectors
Use the I/O connector with external devices in combination with, for example, tampering alarms, motion detection, event triggering,
and alarm notifications. In addition to the 0 V DC reference point and power (DC output), the I/O connector provides the interface to:
Digital output -
For connecting external devices such as relays and LEDs. Connected devices can be activated by the VAPIX®
Application Programming Interface or in the product’s webpage.
Digital input -
For connecting devices that can toggle between an open and closed circuit, for example PIR sensors, door/window
contacts, and glass break detectors.
4-pin terminal block
65