Axis E1, Owner'S Manual

Page: 60 / 74

63
MAINTENANCE
Brakes
The front and rear brakes are hydraulic disc type brakes. Press down on the brake pedal to engage
the brakes. Se e page44.
Brake Fluid
Inspect the brake system routinely. Inspect the level of the brake fluid before each operation.
WARNING! After opening a bottle of brake fluid, always discard any unused portion. Never store or
use a partial bottle. Brake fluid is hygroscopic, meaning it rapidly absorbs moisture from the air. The
moisture causes the boiling temperature of the brake fluid to drop, which can lead to early brake
fade and the possibility of accident or severe injury.
Change the brake fluid every two years and any time the fluid
becomes contaminated, the fluid level is below the minimum,
or if the type and brand of the fluid in the reservoir are
unknown. See page 53 for fluid recommendations.
1. Position the vehicle on a level surface.
2. View the brake fluid level at the reservoir in the driver’s
side wheel well. The level should be between the upper
(MAX) and lower (MIN) level lines.
3. If the fluid level is lower than the upper level line, add
brake fluid to the upper (MAX) line.
4. Apply the brake forcefully for a few seconds and check
for fluid leakage around the fittings.
Brake Inspection
1. Check the brake system for fluid leaks.
2. Check the brake pedal for excessive travel or a spongy
feel.
3. Check the friction pads for wear, damage and
looseness.
4. Check brake discs for signs of cracks, excessive corrosion,
warping or other damage. Clean any grease using an
approved brake cleaner or alcohol.
5. Inspect the brake disc spline and pad wear surface for
excessive wear. Change pads when worn to .030” (0.762
mm).
MAX
①
MIN
②