AXIS PTZ Camera
Instructions
Note
The name and location of parts may vary between devices. For more information, see the device’s installation guide.
• Inspect the dome ring screws, the dome bracket screws, the screws that secure the camera on the mounting bracket, and
the screws that secure the bracket on the wall or on the pole.
• If the screws are loose, tighten the screws to prevent incidents, keep the environmental protection and limit vibrations
(bracket screws). Tighten the screws with regards to each specific torque value in the device’s installation guide.
Example of Q6044
‐
E. (5) dome ring screws (1) dome bracket screws
General camera condition
Purpose:
Make sure that the camera parts are intact. Broken or scratched parts could affect the camera’s general performance.
Actions:
•
Clean the sunshield and the camera casing with a non-abrasive, solvent-free neutral soap or detergent with water and
a soft cloth.
•
If the camera is severely damaged, contact
for guidance, in cooperation with the camera operator.
Inspect the bracket
Purpose:
Make sure that the bracket is operational and provides the best possible conditions.
Actions
:
•
Inspect the bracket and remove insects and dirt.
•
If the camera is installed on an Axis bracket, we recommend installing AXIS T91A6 Pipe Seal inside the bracket. This
increases the level of protection against insects.
Cabling (ethernet)
Purpose:
Avoid network and camera problems, for example power drops, by making sure that the cabling meets the requirements of
your equipment.
Actions:
•
Inspect the cabling to the camera and make sure that they are not bent or brittle.
•
If needed, change the cables or improve the positioning of the cable runs.
•
For more information about the cabling at installations, see the device’s Installation guide or check out Axis general
guidelines at:
axis.com/learning/installation-and-configuration
8