AXIS D2110-VE Security Radar
Configure your device
How to record video from a camera when motion is detected
This example explains how to set up the radar and a camera so that the camera starts recording to the SD card five seconds
before the radar detects motion and to stop one minute after.
Connect the devices:
1. Connect a cable from an I/O output on the radar to an I/O input on the camera.
Configure the I/O port of the radar:
2. Go to
Settings > System > I/O ports
and configure the I/O port as an output and select the normal state.
Create a rule in the radar:
3. Go to
Settings > System > Events
and add a rule.
4. Type a name for the rule.
5. From the list of conditions, select an include zone under
Radar motion
. To set up an include zone, see
6. From the list of actions, select
Toggle I/O while the rule is active
and then select the port that is connected to the camera.
7. Click
Save
.
Configure the I/O port of the camera:
8. Go to
Settings > System > I/O ports
and configure the I/O port as an input and select the normal state.
Create a rule in the camera:
9. Go to
Settings > System > Events
and add a rule.
10. Type a name for the rule.
11. From the list of conditions, select
Digital Input
and then select the port that should trigger the rule.
12. From the list of actions, select
Record video
.
13. Select an existing stream profile or create a new one.
14. Set the prebuffer to 5 seconds.
15. Set the postbuffer to 60 seconds.
16. Select
SD card
from the list of storage options.
17. Click
Save
.
How to turn on a light when motion is detected
Turning on a light when an intruder enters the detection zone can have a deterring effect, and will also improve the image quality of
a visual camera recording the intrusion.
This example explains how to set up the radar and an illuminator so that the illuminator turns on when the radar detects motion and
turns off after one minute.
Connect the devices:
1. Connect one of the illuminator cables to the power supply via the relay port on the radar. Connect the other cable
directly between the power supply and the illuminator.
Configure the relay port of the radar:
2. Go to
Settings > System > I/O ports
and select
Open circuit
as the normal state.
13
